【2025 Upgraded】 3392519 Dryer Thermal Fuse WP3392519 Replacement for Whirlpool Maytag Dryer Thermal Fuse Replaces AP6008325 3388651 694511 WP3392519VP by Romalon (3 Pack)

These Thermal Cut-off Fuses worked perfectly for my Kenmore 700 series Dryer. Make sure to verify your exact Dryer Model because my Fuse was behind the (not behind the back Dryer panel) Lower Front Panel which is the only panel that needs removed. Also unlike a YT Video that shows the Front Blower & Drying Tub/Belt needs removing 1st, the job is "Much Easier" if done in the following (approx. time approx. 1.5 hrs.) manner.1.) Make sure the Dryer Power Cord is unplugged.2.) "Pull" the Dryer away from the Wall & Remove the Dryer Vent Hose from the Dryer Exhaust Vent . MAKE sure to clean the (if needed) Dryer Exhaust Vent & Vent Hose of any seen Lint.3.) Now remove the Lower Dryer Front Panel & Gently lay the Dryer on it's "LEFT" side. You will then have easy access to the Thermal-cut Fuse that can be seen from Rt-side (with said Panel removed) opening.4.) Using the proper Tools , remove the "2" Wire Connectors that are attached to the "2" Thermal Fuse Tabs paying close attention (I marked the Front wire with a Permanent Marker) to their orientation for proper reattchment later.5.) Using a 1/4" Ratchet w/short "Magnetic" extension or similer & a small Socket that fits the "Single" Attachment Screw ...remove said Screw & then pull out/remove the "Blown" Thermal Fuse.6.) Now, install the new Thermal Fuse with a short Magnetic Extension Socket ...being careful "Not" to drop the single Thermal Fuse "Attachment Screw" down into the Dryer Cabinet.7. Now, before reattaching the Dryer Vent Hose ...push your Dryer back closer to it's Electrical Wall Outlet & plug it in to check "IF" the Dryer runs now. If it does then unplug the Dryer again & pull it out from the Wall again to reattach the Dryer Exhaust Hose.8.) Finally ...Pop your lower Front Panel back on & reposition your Dryer to it's normal running location & plug the Power Cord back into the Electrical Outlet.

Worked as should

These are vital to a dryer for safety. If you blow this fuse it is because your dryer is getting too hot. My washer and dryer is in my kitchen behind bi-fold doors. Well they used to be. I removed those bi-fold doors and installed two indoor doors. But you must keep the doors open so there is enough air flow. If not it gets too hot. If the dryer gets too hot it blows this fuse. It is a safety measure so your house don't burn down. My daughter moved back in with me with her kids. Lots of laundry. The doors would close and also there was a laundry basket with towels on top of the dryer. I have had to replace these fuses 5 times since last December. I bought the first couple locally but they were almost $20 each time. So that's when I ordered from this store. Fast delivery and looked the same as the others. Needless to say I bought a whole kit and changed out the heating element and all the parts that go to it. I leave the door open and have not had any problems for a month. I still have 2 of them left and I hope I do not have to use them again. Thank you for your product.

Worked for my kenmore dryer. Love that it comes in a pack of three in case you need another one.

This part works as advertised. It is a bit difficult to install. This is the third or fourth one i have replaced. They were from different Amazon sellers. Cheap part that does not last. Glad I don't have to pay over $100 for a service call to replace a $2 part.

Worked for my Maytag Dryer

Fits perfect. Got my dryer running again. Great price. Good product. Yet to see if there is any longevity but I have my fingers crossed. Even if it lasts 5 or so years, it'll easily be worth the purchase. I got three of them in a pack so it should work out just fine. 😁

Good Good just what I needed . The Dryer came Right On !!!!